The YouTube channel oxtoolco has a video showing lapping of surface plates. Not the same as hand scraping, but the principle of using a reference surface is similar, and the master plate looks like the illustrations in this 100-year old document. Plus I think with modern synthetic diamond abrasives, you can directly lap the plates against each other.
I am no machinist, but I like the glimpse into the hobby/profession shown on channels like this and others that comments have mentioned. In the video, the channel owner hires a company to service his stone regency plates, so there is an expert who comes and uses specialized tools to measure and then flatten the plates (and certify them too). You can see and experience the expertise that the guy has with these physical systems, yet it’s just one niche job in a huge engineering tool chain. It really made me think a lot about metal machining and fabrication, and how those rely on fundamental measurements and properties such as flatness.
Lapping starts at 17:40 (they do surface measurements first): https://youtu.be/EWqThb9Z1jk
I am no machinist, but I like the glimpse into the hobby/profession shown on channels like this and others that comments have mentioned. In the video, the channel owner hires a company to service his stone regency plates, so there is an expert who comes and uses specialized tools to measure and then flatten the plates (and certify them too). You can see and experience the expertise that the guy has with these physical systems, yet it’s just one niche job in a huge engineering tool chain. It really made me think a lot about metal machining and fabrication, and how those rely on fundamental measurements and properties such as flatness.